Solar Circulation Pump – High pressure 6-24v

Description

TOPSFLO Heavy duty 12V DC Solar Power Hot Water Circulation Pump

• Max Flow Rate:20LPM / 5.3GPM
• Max Static Lift:4.5M/14.5′
• Rated Voltage:17V
• Impeller Type:Half-Closed impeller
• Power Consumption :5W 10W 15W 25W
• Liquid Temperature:0-110°C

6 volt-24 volt self regulating

Can be connected directly to a 80W photovoltaic panel or run off an alternative 12V power source like a wall wart.

• Maximum system pressure 10 BAR or 140 PSI
• Voltage 8V to 36V DC, standard 12V
• Max Flow Rate 11.5L a minute
• Max Head Pressure 3M
• Integrated stainless steel 1/2” male fitting Inlet & Outlet
• Start-up power Consumption under 2 Watt

1. 12 month warranty
2. Directly connects to photovoltaic panel, start-up power requires less than 2 Watt
3. Ideal 5W, 10W, 15W, 25W power consumption optional for different sizes SWH systems (can be used with a dedicated 12v 80w panel)
4. The exclusive food grade stainless steel solar DC hot water pump
5. Operates on DC power
6. High efficient ECM brushless DC motor, designed for long life operation of up to 30000 hours
7. Advanced magnetic drive technology for static-seal, without leakage, ever
8. Designed to run with hot water (110° C) and at high pressure(145 Psi)
9. Over voltage protection
10. When the voltage reaches over 28V, the pump has auto-protect and will shut off. When the voltage falls below 28V, the pump will restart automatically.
11. Over load protection function
12. When the current reaches over the rated current, as can arise if the impeller is stuck due to debris. The pump will automatically stop and prevent damage, it will restart when the current falls again.
13.  
14. PV operated

For solar system loops, the TD5 pump can be powered directly from a PV panel. The sun comes up, heat builds in the solar hot water panel and at the same time electricity is made in the PV panel.
The pump slowly starts with the smallest amount of current and pushes the heated water to the storage tank.

Simplicity at its finest eliminates all controllers, thermostats and sensors.

Soft start-up, the TD5 Solar DC pump has a soft start-up feature which reduces high in-rush current. When the photovoltaic panel provides sufficient power, the pump goes through the alignment phase by turning the rotor into the position required for start-up. The processor then waits until the capacitor is sufficiently charged.
This enables a start-up with minimal power (less than two watt).
Cycling due to unsuccessful attempts is minimized, even after prolonged shutdown, the pump will start reliably .
Automatic polarity protection. Red is plus, black is minus, if wrong polarity will not damage the motor for it has the automatic polarity protection function.